| View previous topic :: View next topic |
| Author |
Message |
mrdaniel76
Joined: 18 Apr 2008
Posts: 7
|
| Posted: June 21, 2008, 3:39 pm Post subject: Replaced brush gears and it doesn't work on carpet anymore |
|
|
According to our prior discussion here, I replaced one spur gear and the drive gear and my Roomba Scheduler. Now it runs fine on hard floor but it shuts off the brushes as soon as it goes into carpet.
I ran through the diagnostic procedure #11 and the brushes run fine. I am thinking I didn't put something back together right but I am not sure what.
What can I do to have it running well in carpet again? That's my main use for it.
Thanks a lot! |
|
| Back to top |
|
glo69
Joined: 25 Feb 2007
Posts: 500
Location: Bakersfield, California
|
| Posted: June 21, 2008, 4:24 pm Post subject: |
|
|
| Study this thread http://www.roombareview.com/chat/viewtopic.php?t=1979 and I think you will find the answer to your problem. |
|
| Back to top |
|
mrdaniel76
Joined: 18 Apr 2008
Posts: 7
|
| Posted: June 21, 2008, 5:28 pm Post subject: |
|
|
Thanks a lot. That was indeed the problem. The brush motor was inverted and once corrected it is all good.
The video on this thread was also very helpful:
http://www.roombareview.com/chat/viewtopic.php?t=7703&postdays=0&postorder=asc&start=20
Thanks again! |
|
| Back to top |
|
| Replaced brush gears and it doesn't work on carpet anymore - Click Here to visit the Active Version of this page |
